मॉड्यूल:Convert/doc

यह मॉड्यूल:Convert हेतु प्रलेख पृष्ठ है

This module converts a value from one unit of measurement to another. For example:

{{convert|123|lb|kg}} → 123 pounds (56 kg)

The module is called using a template—parameters passed to the template are used by this module to control how a conversion is performed. For example, units can be abbreviated (like kg), or displayed as names (like kilogram), and the output value can be rounded to a specified precision.

The template that invokes this module is:

Template:Convert

The following modules are required:

Module:Convert – (this module) code to convert units
Module:Convert/data – unit definitions
Module:Convert/text – text messages and parameter names and values

The following modules are optional and are used only if required and if the module exists:

Module:Convert/extra – extra (temporary) unit definitions; used if a unit is not found in Module:Convert/data
Module:ConvertNumeric – code to spell an input value in words (only English is supported)

Many testcase pages are available. Currently, the testcases compare the output from the current Template:Convert with the output from Template:Convert/sandboxlua.

Template:Convert/testcases – template tests

Units are defined in the wikitext of the master list of units. Wikitext copied from that page is translated to create the unit definitions by running a Lua script on a local computer.

User:Johnuniq/Conversion data – master list of unit definitions
Module:Convert/makeunits – script to translate wikitext from User:Johnuniq/Conversion data to Lua source for Module:Convert/data

Module:Convert/data is transcluded into every page using the convert module, so experimenting with a new unit in that module would involve a significant overhead. The Module:Convert/extra module is an alternative which is only transcluded on pages with a unit that is not defined in the main data module.

Configuration

The template that invokes this module can define options to configure the module. For example:

{{#invoke:convert | convert | numdot = , | numsep = . }}

Sets the decimal mark to be a comma, and the thousands separator to be a dot.

Other options, with default values, are:

maxsigfig = 14 – maximum number of significant figures
warnings = no – yes if invalid options should show a warning

Other configuration is available in the translation_table at Module:Convert/text. For example, bn:Module:Convert/text uses:

group = 2 – group numbers 3 digits, then 2 digits
plural_suffix = '' – disable plural unit names (do not append "s")
Tables to translate digits to and from the English digits used in calculations.

Module:Convert/text contains all text used for input parameters and for output messages and categories. For example, lk=on may be used at en.wikipedia to link each displayed unit to its article. The text module could be edited to replace "lk" and "on" with any desired text.